Ceramic Capacitors FAQQDo you take any precautions for setting up the mounting machine when mounting capacitors?

Make sure that the following excessive forces are not applied to the capacitors.

  1. In mounting the capacitors on the printed circuit board, any bending force against them shall be kept to a minimum to prevent them from any bending damage or cracking. Please take into account the following precautions and recommendations for use in your process.
    (1) Adjust the lowest position of the pickup nozzle so as not to bend the printed circuit board.

  2. Dirt particles and dust accumulated between the suction nozzle and the cylinder inner wall prevent the nozzle from moving smoothly. This imposes greater force upon the chip during mounting, causing cracked chips. Also, the locating claw, when worn out, imposes uneven forces on the chip when positioning, causing cracked chips. The suction nozzle and the locating claw must be maintained, checked and replaced periodically.

*For each individual warranty information, please review our product specifications or consult the approval sheet.
For more information of main products, please check the detail spec sheet on our website.

Ceramic Capacitor Product Search

<Related FAQ>
・Do you take any precautions for dividing the base after mounting capacitors?

・What is the defense against distortion crack of Multilayer Ceramic Capacitors?

We appreciate your cooperation with the FAQ improvement questionnaire.
Were these FAQs helpful?

We would like to hear your opinions and requests regarding these FAQs.
Opinions from customers will be used to improve the FAQs.
We will not respond to inquiries and requests received by this form.

For product inquiries, please contact us using our contact form.